Digium single channel analog modules allow 400 Series or 800 Series telephony cards to terminate one (1) line (FXO) or station (FXS) connections per module.
Digium quad channel analog modules allow 800 Series or 2400 Series telephony cards to terminate four (4) line (FXO) or station (FXS) connections per module.
Digium Telephony boards come standard with full-height brackets for standard mounting. Optional low-profile brackets are available for all low-profile cards to enable mounting into 1-U servers.
FXS modules provide ringing voltage and battery to telephones or handsets and require substantial amount of 12V DC power in order to operate properly. The PCI interface on motherboards cannot provide sufficient quantities of this voltage necessary to ring 4, 8 or 24 modules. As a solution, Digium analog cards are mounted with a 4-pin disk-drive or Molex connector on the base board. This connector must be supplied with an internal power connector from the system's power supply if FXS modules are in use.
DSP-based echo cancellation modules for all of our analog and digital (T1/E1/J1) cards with the VPMOCT series modules.
Straight-through and cross-over cables for connecting Digium T1/E1 interface cards and T1/E1 ports, telephone cables for interfacing analog cards, and timing cables for digital cards.
The Sangoma Power Adapter draws +12 V power from your standard PCIe slot and sends it to a standard Molex connector. Its unique design does not reduce the number of PCIe slots available in your system.
Use this kit of twelve RJ11/4 plugs and a crimping tool to hardwire your Sangoma A200 system.
6 position, 2 conductor, 24-port/1 RMS (rack mount space) Telco patch panel. Integrated with 1 Telco connector and includes # 12 rack screws. Uses a female amphenol connector.
Sangoma’s T1/E1 line tapping solution is a high performance, robust and inexpensive toolkit that gives you complete access to the T1/E1 voice and signalling interfaces. Based on the popular A102, A104 and A108 AFT cards, the system supports the line tapping of one, two and four T1/E1 lines per card respectively.
Up to four TE2/4XXP cards to share the same sync (timing) source from the T1/E1 provider, or provide a consistent sync source across multiple cards.
The timing cable allows up to three Hx8 or TE8xx cards to share the same sync (timing) source from the T1/E1 provider, or provide a consistent sync source across multiple cards.
The 7 foot shielded, cross-over cable is used for connecting Digium T1/E1 interface cards to the PSTN or other T1/E1 equipments. The cross-over cable is the standard cable that should be used to connect T1/E1 ports to T1/E1 ports or equipment.
For the A142, A144 Standard | Male | ROHS: Yes | Length: 6′
Standard cable for A142V
Standard | ROHS: Yes | Length: 1′
Standard cable for A144R Standard | ROHS: Yes | Length: 1′
Standard cable for A144V
Standard | ROHS: Yes | Length: 15′
Only Sold Separately | ROHS: Yes | Length: 6″
1 pair of 6’ BNC shielded Coaxial Cable for DS-3 Tx and Rx
Price for these items will be determined by a Sangoma representative on per order basis.
Please contact us if you have any questions.
Special Order | ROHS: Optional | Length: 10′
Special Order | ROHS: Optional | Length: 10′
For the USBfxo Standard | Length: 6′
For the USBfxo and B600 FXS Standard | Length: 6′
